daver clasper Posted June 11, 2015 Share Posted June 11, 2015 Hi everoneHave installed both outer bearing cups into hub. Have fitted the felt seal holder cup with the flange facing towards vertical link. Wondering how far this goes in. At present the holder lip edge is flush with the flange lip of hub.ThanksDave Quote Link to comment Share on other sites More sharing options...
Pete Lewis Posted June 13, 2015 Share Posted June 13, 2015 thats about right just flush.the back of the cup sits against the bearing face re check the end float once the seals had a short run.Pete Quote Link to comment Share on other sites More sharing options...
daver clasper Posted June 14, 2015 Author Share Posted June 14, 2015 Cheers Pete.Thats really helpful.I guess its not its not massivly critical, as long as there is a bit of free play in the hub.ThanksDave Quote Link to comment Share on other sites More sharing options...
Pete Lewis Posted June 15, 2015 Share Posted June 15, 2015 yes , keep some end play, a light nip on the nut and back 1 + flats is fine if its tight youre in for a quick and expensive siezuresounds like you have it right, some aftermarket felts and cups were very oversize and didnt fit anywherePete Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.