ikar888 Posted March 25, 2012 Share Posted March 25, 2012 Hello,Please give me information, what the size is oil seal crankshaft front UKC1110 (mm or inch).Best regards Bogdan Link to comment Share on other sites More sharing options...
ikar888 Posted April 4, 2012 Author Share Posted April 4, 2012 I did not know that this secret :( Link to comment Share on other sites More sharing options...
Nick Jones Posted April 4, 2012 Share Posted April 4, 2012 Oil seals are specified by inside diameter (Shaft size) x outside diameter (housing bore) x thickness (less critical, typically 6 - 8mm)So by measuring the diameter of the crankshaft nose were the seal runs and the diameter of the housing you should get a pretty good idea. Of course, the numbers you get may not be a standard general engineering size quite a lot of the automotive ones are not.If you get the choice, a double lip seal usually seals better and Viton will last better in the hot, hostile conditions of the engine.Hope this helpsNick Link to comment Share on other sites More sharing options...
ikar888 Posted April 4, 2012 Author Share Posted April 4, 2012 OK! :) " inside diameter (Shaft size) x outside diameter (housing bore) x thickness " it is obviousCosts originally seal in Poland about 10 pounds. I wanted to choose a cheaper replacement before removal.I greetBogdan Link to comment Share on other sites More sharing options...
ikar888 Posted April 22, 2012 Author Share Posted April 22, 2012 4817 wrote:Hello,Please give me information, what the size is oil seal crankshaft front UKC1110 (mm or inch).Best regards Bogdan 2X3X0,375 inch ;) Link to comment Share on other sites More sharing options...
Velocita Rosso Posted April 22, 2012 Share Posted April 22, 2012 If you are talking about the crankshaft/timing cover oil seal, then if you get stuck the MG midget stockist will carry the identical seal Link to comment Share on other sites More sharing options...
Tinweevil Posted May 27, 2012 Share Posted May 27, 2012 UKC1110 is a 1945. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.