Petefeet Posted December 16, 2014 Share Posted December 16, 2014 Hi, I have seen a 2.5 ltr engine on eBay, it's an MG prefix which I think is from a 69-70 saloon. My question is will it fit in my mk1 67 gt6 . Will it need anything adjusted to fit, can it take the std carbs and inlet manifold from my current engine, will it need a different gearbox or will it just bolt in connect it up and go! Appreciate any advice.TaPete Quote Link to comment Share on other sites More sharing options...
Nick Moore Posted December 16, 2014 Share Posted December 16, 2014 I don't think it will be a straight swap. The 2.5 head is different from a Mk1’s, so you'll need different inlet and exhaust manifolds. They're not hard to find. The sump will also need modifying to clear the steering rack, or you could modify your GT6 motor's sump to clear the longer throw crankshaft. That's what I did.Remember, though, that the 2.5's torque will increase stress on the gearbox and diff. They're a bit marginal with the standard engine. You can fit different gearboxes or modify your existing box, and can strengthen or replace the diff.My recipe is a 2.5 engine, Toyota Supra gearbox and Subaru diff. Quote Link to comment Share on other sites More sharing options...
don cook1 Posted December 16, 2014 Share Posted December 16, 2014 I think you have to swop over the front engine plate...or cut off the mounts. Quote Link to comment Share on other sites More sharing options...
Petefeet Posted December 16, 2014 Author Share Posted December 16, 2014 Thanks guys, that's been helpful, much appreciated. Quote Link to comment Share on other sites More sharing options...
cook1e Posted December 16, 2014 Share Posted December 16, 2014 My Gt6 had a Saloon engine in it and still had the front plate fitted but without the rubber mounts. I just took an angle grinder to the brackets on the front plate with it in situ to remove them!I ran around like this for quite a while until I eventually replaced with a recon unleaded GT6 engine from Kippings back in the day. Quote Link to comment Share on other sites More sharing options...
Clive Posted December 17, 2014 Share Posted December 17, 2014 Probably need to use your existing flywheel. and almost definately your sump modded with 2 dents to clear the crank. Late vitesse/GT6 inlet and exhaust manifolds, and really you want large carbs (from a dolly sprint) plus the exhaust from a later GT6 as yours is a smaller bore.All pretty much bolt-on stuff. Quote Link to comment Share on other sites More sharing options...
John Bonnett Posted December 17, 2014 Share Posted December 17, 2014 9234 wrote:Hi, I have seen a 2.5 ltr engine on eBay, it's an MG prefix which I think is from a 69-70 saloon. My question is will it fit in my mk1 67 gt6 . Will it need anything adjusted to fit, can it take the std carbs and inlet manifold from my current engine, will it need a different gearbox or will it just bolt in connect it up and go! Appreciate any advice.TaPetePM sentJohn Quote Link to comment Share on other sites More sharing options...
ahebron Posted December 18, 2014 Share Posted December 18, 2014 Will also need to fit the rear plate from the GT6 to the 2.5 engine to bolt the GT6 gearbox too.The saloon engines are canted over and I think use different bolt spacings.You will see how much by looking at the side slope on the base of the sump.Adrian Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.